The Same Four Stops, Every Appointment
A single club or a complete bag rebuild both move through the identical sequence — and unlike most fitting shops, we lock a ball compression band in before we ever pull a demo head off the wall.
Record Baseline
Whatever you currently play goes on the bay first — clubs and ball — alongside a short conversation about typical misses and how often you get out to play.
Set the Compression Band
Your measured clubhead speed determines the compression band before any club testing starts, so ball comparisons run on real numbers, not a guess.
Bay Comparisons
Relevant heads, shafts, and ball models come off the wall and rack, tested back-to-back against the recorded baseline rather than an abstract standard.
Assemble & Confirm
Finished clubs get built on-site and checked against frequency and swing-weight targets before pickup, typically within a week.
You Watch the Numbers Move
A monitor sits where you can see it throughout the appointment. Rather than taking someone's word that one option "should" outperform another, you watch carry, dispersion, and compression match shift in real time as we swap parts.
- Every swing recorded, not a cherry-picked average
- Direct comparison charts, baseline against every alternative tested
- A printed spec sheet ready before you leave, or emailed same day
- Nothing here requires a follow-up order
Watch Your Own Numbers Change
Book a session and see your compression band and dispersion pattern shift while we adjust specs.